subject
Physics, 14.07.2020 19:01 hey840

13. A hole is drilled in a block of wood as shown in the sketch. The hole is 3/4 of the total depth of the wood. The total depth of the block of wood is 13/16 in.
How deep is the hole?
Hole

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 17:10
Aprojectile is launched horizontally 10m above the ground and with an initial velocity of 15 m/s. a) sketch the trajectory using an appropriate coordination system. b) how long for the projectile to reach the ground. c) how far did projectile travel horizontally before striking the ground. d) determine the projectilex & y position at t-1.3s e) determine the magnitude and direction of projectile velocity at t= 1.3s f) determine the magnitude and direction of projectile acceleration at t-1.3s
Answers: 1
question
Physics, 22.06.2019 06:20
Clothing made of several thin layers of fabric with trapped air in between, often called ski clothing, is commonly used in cold climates because it is light, fashionable, and a very effective thermal insulator. so it is no surprise that such clothing has largely replaced thickand heavy old-fashioned coats. (a) consider a jacket made of five layers of 0.1-mm-thick synthetic fabric (k = 0.13 w/m·°c) with 1.5-mm-thick air space (k = 0.026 w/m·°c) between the layers. assuming the inner surface temperature of the jacket to be 28°c and the surface area to be 1.25 m2, determine the rate of heat loss through the jacket when the temperature of the outdoors is 0°c and the heat transfer coefficient at the outer surface is 25 w/m2·°c. (b) what would your response be if the jacket is made of a single layer of 0.5-mm-thick synthetic fabric? what should be the thickness of a wool fabric (k = 0.035 w/m·°c) if the person is to achieve the same level of thermal comfort wearing a thick wool coat instead of a five-layer ski jacket?
Answers: 1
question
Physics, 22.06.2019 10:30
Air is to be preheated by hot exhaust gases in a cross-flow heat exchanger before it enters the furnace. air enters the heat exchanger at 95 kpa and 20°c at a rate of 0.6 m^3/s. the combustion gases (cp = 1.10 kj/kg°c) enter at 160°c at a rate of 0.95 kg/s and leave at 95°c. determine the rate of heat transfer to the air and its outlet temperature.
Answers: 2
question
Physics, 22.06.2019 13:40
Consider a double atwood machine constructed as follows: a mass 4m is suspended from a string that passes over a massless pulley on frictionless bearings. the other end of this string supports a second similar pulley, over which passes a second string supporting a mass of 3m at one end and m at the other. using two suitable generalized coordinates, set up the lagrangian and use the lagrange equations to find the acceleration of the mass 4m when the system is released. explain why the top pulley rotates even though it carries equal weights on each side.
Answers: 2
You know the right answer?
13. A hole is drilled in a block of wood as shown in the sketch. The hole is 3/4 of the total depth...
Questions
question
Mathematics, 18.08.2019 15:00
question
Physics, 18.08.2019 15:00
question
English, 18.08.2019 15:00
question
Mathematics, 18.08.2019 15:00
Questions on the website: 13722360