Design and sketch masks to be used with negative photoresist for making an array of five wires of smallest width 2 μm on a silicon wafer. The wires are to be connected at each end to contact pads (1 mm2) for wire bonding. The wires are to be broken to have 20 nm gaps. What technique would you use to do this? The wire to be broken must be thin (no more than 50 nm) but the contact pads need to be thick (1 μm) for wire bonding. Outline the steps you might take to make the final device. You may have to research resist treatments for lift-off.

What is an electric motor? explain its operation. 2-3 sentence

Which of the following is a false statement about dispersion forces? view available hint(s) which of the following is a false statement about dispersion forces? dispersion forces are the result of fluctuations in the electron distribution within molecules or atoms. dispersion forces are present in all atoms and molecules. dispersion forces result from the formation of instantaneous dipoles in a molecule or atom. dispersion forces always have a greater magnitude in molecules with a greater molar mass. dispersion force magnitude depends on the amount of surface area available for interactions.

Momentum lab this lab uses a phet simulation. navigate to the phet momentum simulation. if you don’t see the image below when you click on the link, then you need to either enable adobe flash (click on the puzzle piece on your screen) or you need to install adobe flash (this is a free program). change the vectors to be momentum vectors only. they are yellow. make the mass of both balls the same. hit play and notice what happens to the momentum vectors before and after the collision. you might want to play the sim multiple times. click on restart or return balls to start over. to see numbers, check the show values box (inside the green box). red’s momentum vector before the collision is green’s momentum vector after the collision. question 1 options: shorter than longer than equal to question 2 (1 point) saved since green bounces off red, this must be an collision. question 2 options: explosion inelastic elastic question 3 (1 point) red transfers of its momentum to green during the collision. question 3 options: little all most none question 4 (4 points) why does red transfer all its momentum to green? back up your answer with information from the simulation. write at least 2 sentences.