Assuming 100% efficient energy conversion, how much water stored behind a 50 centimeter high hydroelectric dam would be required to charge the battery?

Complete question is;

Assuming 100% efficient energy conversion how much water stored behind a 50 centimeter high hydroelectric dam would be required to charge the battery with power rating, 12 V, 50 Ampere-minutes.

Amount of water required to charge the battery = 7.35 m³

Explanation:

The formula for Potential energy of the water at that height = mgh

Where;

m = mass of the water

g = acceleration due to gravity = 9.8 m/s²

h = height of water = 50 cm = 0.5 m

We know that in density, m = ρV

Where;

ρ = density of water = 1000 kg/m³

V = volume of water

So, potential energy is now given as;

Potential energy = ρVgH = 1000 × V × 9.8 × 0.5 = (4900V) J

Now, formula for energy of the battery is given as;

E = qV

We are given;

q = 50 A.min = 50 × 60 = 3,000 C

V = 12 V

Thus;

qV = 3,000 × 12 = 36,000 J

E = 36,000 J

At a 100% conversion rate, the energy of the water totally powers the battery.

Thus;

(4900V) = (36,000)

4900V = 36,000

V = 36,000/4900

V = 7.35 m³

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).