Assemble the electromagnetic spectrum by dragging each piece to the correct place on the wavelength scale.

long wave with a frequency of nos 10⁶ Hz, to radio waves

*  order of 10⁸ Hz TV and FM

* in the 10⁹ to 10¹¹ Hz microwave range

* in the range of 10¹² to 10¹⁴ infrared waves,  thermal  energy

* in the range of 10¹⁴ visible light captured by humans

* for range 10¹⁵ to 10¹⁸ UV light

* in the range of 10¹⁶ to 10²⁰ X-rays

* for more than 10¹⁹ Hz cosmic rays

Explanation:

The electromagnetic spectrum is formed by transverse waves that are the oscillations of electric and magnetic fields

             c = λ f

in general this spectrum is divided into range depending on the uses of the waves

from lower frequency to higher we have

* long wave with a frequency of nos 10⁶ Hz, corresponds to radio waves

* tv wave and modulated frequency, of the order of 10⁸ Hz, television and FM radio

* in the 10⁹ to 10¹¹ Hz microwave range

* in the range of 10¹² to 10¹⁴ infrared waves,  

* in the range of 10¹⁴ visible light captured by humans

* for range 10¹⁵ to 10¹⁸ UV light

* in the range of 10¹⁶ to 10²⁰ X-rays

* for more than 10¹⁹ Hz cosmic rays

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

the answer is b, have negligible mass