subject
Physics, 05.05.2020 04:09 dajahp

She uses a voltmeter, that measures in volts, and an ammeter that measures in amps. Both were correctly placed in her circuit. In her notes she wrote x = 0.15 z = 0.3 but did not indicate volts or amps, or which meter was which. The resistor on the left is 5 ohms. (A) Which was the ammeter? explain. (B) What is the voltage difference across each resistor? Explain. (C) What is the voltage of the battery? Explain.

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 00:00
During physical science, ms. greene challenged her students to produce an energy transformation. james and jill wrapped a 4-inch nail with a coil of fifty turns of wire. they connected one end of the coil to one terminal of a knife switch. they connected the other terminal of the knife switch to the battery. finally, they connected the end of the coil to the other terminal of the battery. james held the tip of a 1-inch nail near the flat end of the 4-inch nail. jill closed the knife switch quickly and then opened it. the 1-inch nail was pulled toward the 4-inch nail. what is the best explanation of why the nail moved? a) electrical energy was converted to mechanical energy in the 1-inch nail. b) the 4-inch nail became an electromagnet and the magnetic force attracted the 1-inch nail. c) the electric current in the 4-inch nail was converted to mechanical energy in the 1-inch nail. d) the 4-inch nail had a positive charge and the 1-inch nail had a negative charge. opposites attracted.
Answers: 1
question
Physics, 22.06.2019 02:50
Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)
Answers: 3
question
Physics, 22.06.2019 08:30
Abike rider starts from rest and accelerates 28.0 meters down a slope in 5.00 seconds. what is her acceleration? select one: a. 3.21 m/sec2 b. 1.75 m/sec2 c. 9.80 m/sec2 d. 2.24 m/sec2
Answers: 3
question
Physics, 22.06.2019 16:20
What is the single most important equation in all of physics?
Answers: 1
You know the right answer?
She uses a voltmeter, that measures in volts, and an ammeter that measures in amps. Both were correc...
Questions
question
History, 14.10.2019 05:30
Questions on the website: 13722366