subject
Physics, 06.05.2020 06:29 amontgomery51

: Two containers have a substantial amount of the air evacuated out of them so that the pressure inside is half the pressure at sea level. One container is in Denver at an altitude of about 6,000 ft and the other is in New Orleans (at sea level). The surface area of the container lid is 4 -0.0155 m. The air pressure in Denver is PD - 79000 Pa. and in New Orleans is Pro=100250 Pa. Assume the lid is weightless.

Part (a) Write an expression for the force FNo required to remove the container lid in New Orleans.
Part (b) Calculate the force Fno required to lift off the container lid in New Orleans, in newtons.
Part (c) Calculate the force Fp required to lift off the container lid in Denver, in newtons.
Part (d) is more force required to lift the lid in Denver (higher altitude, lower pressure) or New Orleans (lower altitude, higher pressure)?

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 18:20
Find the vertex(use the completing the square method), findthe x- and y-intercepts, and sketch the graph offunction. y = 2x2 + 4x - 1
Answers: 3
question
Physics, 22.06.2019 04:20
Awave is produced in a rope. the wave has a speed of 33 m/s and a frequency of 22 hz. what wavelength is produced?
Answers: 2
question
Physics, 22.06.2019 07:30
Some material consisting of a collection of microscopic objects is kept at a high temperature. a photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of 0.3 ev, 0.5 ev, 0.8 ev, 2.0ev, 2.5ev, and 2.8ev. these are the only photon energies observed. (a) draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. on the diagram, indicate the transitions corresponding to the emitted photons. explain briefly. (b) would a spring–mass model be a good model for these microscopic objects? why or why not? (c) the material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. what photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? explain briefly.
Answers: 3
question
Physics, 23.06.2019 04:31
Ahockey puck sliding along frictionless ice with speed v to the right collides with a horizontal spring and compresses it by 3.0 cm before coming to a momentary stop.
Answers: 2
You know the right answer?
: Two containers have a substantial amount of the air evacuated out of them so that the pressure ins...
Questions
question
Mathematics, 03.08.2019 20:00
Questions on the website: 13722367