Physics, 23.04.2020 18:55 ashtonbillups

All organisms require a set of instructions that specify its traits. The instructions that are responsible for all the inherited traits of an organisms

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 15:00

Aman does 500 j of work pushing a car a distance of 2 m. how much force does he apply? assume there is no friction. a. 250 n b. 1000 n c. 125 n d. 500 n

Answers: 1

Answer

Physics, 21.06.2019 19:30

Is it possible to use the energy from two atoms colliding to create a clean burning lasting fuel source with a large amount of force? is it also possible to harness that energy from the two atoms colliding to create a clean energy source that will last for years from just two atoms colliding. is there a possibility to control and store that energy for years but slowly let the energy out enough to power cities cheaper and faster.

Answers: 3

Answer

Physics, 22.06.2019 00:10

The energy released by a chemical reaction can be measured using a calorimeter. when barium hydroxide octahydrate crystals are reacted with dry ammonium chloride inside of a coffee cup calorimeter, the temperature of the 18.00 g of water in the calorimeter decreases from 30.0°c to 8.0°c. the equation for calculating energy absorbed or released by a reaction is: where q is the energy released or absorbed, m is the mass of water in the calorimeter, cp is the specific heat of water, and δt is the observed temperature change. if the specific heat of liquid water is 4.19 j/g·°c, how much energy was absorbed by the reaction?

Answers: 3

Answer

Physics, 22.06.2019 03:10

Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.

Answers: 2

Answer

You know the right answer?

All organisms require a set of instructions that specify its traits. The instructions that are respo...

Questions