Physics, 16.04.2020 04:35 darkremnant14

Why are the peaks opposite in direction?

a. The peaks are opposite in direction because the change in magnetic field at one end of the coil is opposite to the change in magnetic field at the other end. Faraday's law predicts that the direction of the induced voltage is dependent on the nature of the change in magnetic field.

b. The peaks are opposite in direction because the change in magnetic field at one end of the coil has the same direction to the change in magnetic field at the other end. Faraday's law predicts that the direction of the induced voltage is dependent on the nature of the change in magnetic field.

c. The peaks are in the same direction because the change in magnetic field at one end of the coil has the same direction to the change in magnetic field at the other end. Faraday's law predicts that the direction of the induced voltage is dependent on the nature of the change in magnetic field

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 20:30

Determine the amount of work done when a crane lifts a 100-n block form 2m above the ground to 6m above the ground

Answers: 1

Answer

Physics, 21.06.2019 20:50

Aball is thrown upward in the air, and its height above the ground after t seconds is h ( t ) = 57 t − 16 t 2 feet. find the time t when the ball will be traveling upward at 14.25 feet per second.

Answers: 1

Answer

Physics, 22.06.2019 02:30

Agas initially at p1 = 1 bar and occupying a volume of 0.5 liter is compressed within a piston–cylinder assembly to a final pressure p2 = 4 bar. (a) if the relationship between pressure and volume during the compression is pv = constant, determine the volume, in liters, at a pressure of 3 bar. (b) repeat for a linear pressure–volume relationship between the same end states. reference

Answers: 1

Answer

Physics, 22.06.2019 02:50

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Answers: 3

Answer

You know the right answer?

Why are the peaks opposite in direction?

a. The peaks are opposite in direction because...

Questions