A solenoidal coil with 25 turns of wire is wound tightly around another coil with 320 turns. The inner solenoid is 23.0cm long and has a diameter of 2.00cm . At a certain time, the current in the inner solenoid is 0.150A and is increasing at a rate of 1600A/sPart AFor this time, calculate the average magnetic flux through each turn of the inner solenoid. Part BFor this time, calculate the mutual inductance of the two solenoids;Part CFor this time, calculate the emf induced in the outer solenoid by the changing current in the inner solenoid.

see the answers below please

Explanation:

We have that the current in the inner solenoid is:

A) the magnetic flux is given by

B is obtained by computing for a solenoid:

hence, we have

B)

the mutual inductance is obtained by using:

C)

hope this helps!!

Part A, magnetic flux = 9.02 × 10^-8 Wb

Part B, mutual inductance, M = 1.50 × 10^-5H

Part C, emf induced in the outer solenoid = -0.024V

Explanation: Please see the attachments below

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

i would think it's food chain