The photometer is a device that converts light to voltage which is read out by the digital multimeter (DMM). This is due to the photoelectric effect. (Einstein won his Nobel Prize for his explanation of the photoelectric effect.) In the photoelectric effect, light hits a piece of metal. Quantum mechanics tells us that light can be thought of as tiny packets of energy called photons. The photons are absorbed by electrons and increase the energy of the electrons. Some of the electrons become so energetic that they escape from the metal. In other words electrons are emitted from the metal, producing a current that is amplified by the photometer. The current goes through a resistor in the photometer. Ohm's law (V=IR) tells us that current I going through a resistor R is associated with a voltage drop V. The DMM measures the voltage drop across the resistor. Saturation occurs when the metal emits the maximum flux of electrons that it can produce. (Or it may be the maximum amplification of the photometer.)
What does a photometer do?
B. It converts light into electric current.

A. It emits light.
B. It converts light into electric current.
C. It measures the frequency of light.
D. It emits sound.

Option B

It converts light into electric current

Explanation:

A photometer is a device used to measure illuminance

Its principle of operation hinges on the conversion of light into electric current, using photoresistor or any other light sensitive device such as  a photodiode.  This is so that it can be read off easily by any other device.

A Photoresistor is a device that changes the flow of current through it when it is exposed to light rays.  A photometer works by irradiating a photo resistor, which then converts the light rays incident on it to electric current.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).