Physics, 09.04.2020 15:35 gbrbogdan9665

A parallel plate capacitor is connected to a battery and fully charged. Its plates are then moved closer together. Which of the following correctly describes the difference between the plates being moved after the capacitor is isolated versus the plates being moved while the capacitor is still connected to the battery?

A. If the capacitor was isolated, the charge stored was constant; if the capacitor was still connected to the battery, the potential difference across its plates increased.

B. If the capacitor was isolated, the charge stored increased; if the capacitor was still connected to the battery, the potential difference across its plates increased.

C. If the capacitor was isolated, the charge stored was constant; if the capacitor was still connected to the battery, the potential difference across its plates was constant.

D. If the capacitor was isolated, the charge stored increased; if the capacitor was still connected to the battery, the potential difference across its plates was constant.

E. More than one of the above is correct.

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 19:30

Note: the following questions are unrelated to the balmer series or the martian. refer to your course notes. a sun-sized star will spend most of its lifetime as a: white dwarf b. red giant c. protostar d. main-sequence star

Answers: 2

Answer

Physics, 22.06.2019 01:10

Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)

Answers: 3

Answer

Physics, 22.06.2019 08:00

Hydrogen and helium are both members of?

Answers: 2

Answer

Physics, 22.06.2019 10:50

Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.

Answers: 3

Answer

You know the right answer?

A parallel plate capacitor is connected to a battery and fully charged. Its plates are then moved cl...

Questions