Water is flowing into a factory in a horizontal pipe with a radius of 0.0183 m at ground level. This pipe is then connected to another horizontal pipe with a radius of 0.0420 m on a floor of the factory that is 12.6 m higher. The connection is made with a vertical section of pipe and an expansion joint. Determine the volume flow rate that will keep the pressure in the two horizontal pipes the same.

Aheavy piece of hanging sculpture is suspended by a90-cm-long, 5.0 g steel wire. when the wind blows hard, the wire hums at its fundamental frequency of 80hz. what is the mass of the sculpture?

Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?

A15,000 kg rocket traveling at +230 m/s turns on its engines. over a 6.0 s period it burns 1,000 kg of fuel. an observer on the ground measures the velocity of the expelled gases to be −1,200 m/s.