subject
Physics, 04.04.2020 08:34 genyjoannerubiera

At t = 0, a particle leaves the origin with a velocity of 9.0 m/s in the positive y direction. What else is always true Group of answer choices the object is in free fall the x velocity = 0 m/s the y acceleration = -9.80 m/s2 the object starts at the origin

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 23:00
1point) a skydiver weighing 130 lb (including equipment) falls vertically downward from an altitude of 14,000 ft and opens the parachute after 20 s of free fall. assume that the force of air resistance, which is directed opposite to the velocity, is of magnitude 0.85|v|0.85|v| when the parachute is closed and is of magnitude 17|v|17|v| when the parachute is open, where the velocity vv is measured in ft/s. assume that acceleration due to gravity has magnitude 32 ft/s/s; remember that weight is the product of mass and gravitational acceleration. find the speed of the skydiver when the parachute opens. speed is 150.6121788 ft/s find the skydiver's height when the parachute opens. height is 2338.98591 ft find the limiting velocity vlvl after the parachute opens. (think about whether this should be positive or negative.) vl=vl= 7.647 ft/s
Answers: 2
question
Physics, 22.06.2019 01:10
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
question
Physics, 22.06.2019 08:00
Hydrogen and helium are both members of?
Answers: 2
question
Physics, 22.06.2019 14:20
Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.
Answers: 1
You know the right answer?
At t = 0, a particle leaves the origin with a velocity of 9.0 m/s in the positive y direction. What...
Questions
question
Geography, 23.06.2019 07:30
question
Social Studies, 23.06.2019 07:30
Questions on the website: 13722363