subject
Physics, 03.04.2020 02:48 bdjxoanbcisnkz

A group of researchers analyzes the results from a nuclear collider experiment. The analysis shows that the nuclei involved in the collision had charges of 9.6 x 10^-19 C with a margin of error of 0.1 x 10^-19 C. The magnitude of an electron's charge is e = 1.60x10 ^-19 C. What could be a reasonable conclusion about this result? a. Something probably went wrong, since charge must be less than or equal to e. b. The result seems reasonable, since charge must be an integer multiple of e. c. The result seems reasonable, since charge must be greater than e. d. Something probably went wrong, since charge must be a multiple of e.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 18:00
Alivestock company reports that the mean weight of a group of young steers is 1100 pounds with a standard deviation of 93 pounds. based on the model n(1100,93) for the weights of steers, what percent of steers weigh a) over 1050 pounds? b) under 1300 pounds? c) between 1150 and 1250 pounds?
Answers: 1
question
Physics, 21.06.2019 21:20
An artificial satellite circles the earth in a circular orbit at a location where the acceleration due to gravity is 6.03 m/s^2. determine the orbital period of the satellite.
Answers: 3
question
Physics, 22.06.2019 07:50
The ratio of lift to drag l/d for a wing or airfoil is an important aerodynamic parameter, indeed, it is a direct measure of the aerodynamic efficiency of the wing. if a wing is pitched through a range of angle of attack, l/d first increases, then goes through a maximum, and then decreases. consider an infinite wing with an naca 2412 airfoil. estimate the maximum value of l/d. assume that the reynolds number is 9x10^6.
Answers: 2
question
Physics, 22.06.2019 12:30
Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question
Answers: 1
You know the right answer?
A group of researchers analyzes the results from a nuclear collider experiment. The analysis shows t...
Questions
Questions on the website: 13722367