Physics, 24.03.2020 01:55 kerryanne78

Two resistors of resistances R1 and R2, with R2>R1, are connected to a voltage source with voltage V0. When the resistors are connected in series, the current is Is. When the resistors are connected in parallel, the current Ip from the source is equal to 10Is.

Let r be the ratio R1/R2. Find r. Round your answer to the nearest thousandth.

Answers: 1

Show answers

Answers

Answer from: Cheyanne5627

Answer

The Value of r = 0.127

Explanation:

The mathematical representation of the two resistors connected in series is

R_T = R_1 +R_2

And from Ohm law

$I_s =\frac{ V}{R_T}$

$I_s = \frac{V_0}{R_1 +R_2} ---(1)$

The mathematical representation of the two resistors connected in parallel is

$R_T = \frac{1}{R_1} +\frac{1}{R_2}$

$= \frac{R_1 R_2}{R_1 +R_2}$

From the question I_p =10I_s

=> $I_p =10I_s = \frac{V_0 }{\frac{R_1R_2}{R_1 +R_2} } = \frac{V_0 (R_1 +R_2)}{R_1 R_2}---(2)$

Dividing equation 2 with equation 1

=> $\frac{10I_s}{I_s} =\frac{\frac{V_0 (R_1 +R_2)}{R_1 R_2}}{\frac{V_0}{R_1 +R_2}}$

$10 = \frac{(R_1+R_2)^2}{R_1 R_2}----(3)$

We are told that $r = \frac{R_1}{R_2} \ \ \ \ \ = R_1 = rR_2$

From equation 3

$10 = \frac{(1-r)^2}{r}$

$= \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ 1+r^2 + 2r = 10r$

$= \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ r^2 -8r+1 = 0$

Using the quadratic formula

$r =\frac{-b\pm \sqrt{(b^2 - 4ac)} }{2a}$

a = 1 b = -8 c =1

$= \frac{8 \pm\sqrt{((-8)^2- (4*1*1))} }{2*1}$

$r= \frac{8+ \sqrt{60} }{2} \ or \ r = \frac{8 - \sqrt{60} }{2}$

$r = \ 7.87\ or \ r \ = \ 0.127$

Now r = 0.127 because it is the least value among the obtained values

Answer from: Quest

the answer is a)

mark brainliest

Answer from: Quest

-first use of geothermal energy occurred more than 10,000 years ago in north america by american paleo-indians

-the first industrial use of geothermal energy began near pisa, italy in late 18th century

-in 1904, italian scientist piero ginori conti invented the first geothermal electric power plant in which steam was used to generate the power

-with the above experiment, the first geothermal plant in usa started in 1922 with a capacity of 250 kilowatts

-however, in 1946 first ground-source geothermal heat pump installed at commonwealth building in portland, oregon

-during the 1960’s, pacific gas and electric began operation of first large scale geothermal power plant in san francisco, producing 11 megawatts

-in 1973, when oil crisis began many countries began looking for renewable energy sources and by 1980’s geothermal heat pumps (ghp) started gaining popularity in order to reduce heating and cooling costs

-as effect of climate change started showing results, governments of various countries joined hands to fight against it, for which kyoto protocol was signed in japan in 1997, laid out emission targets for rich countries and required that they transfer funds and technology to developing countries, 184 countries have ratified it

hope this

Another question on Physics

Physics, 22.06.2019 02:40

15. one purpose of the tread pattern on a tire is to a reduce tire wear. b. reduce traction c. allow water to flow away from the tire. d. look impressive.

Answers: 1

Answer

Physics, 22.06.2019 10:10

What is the angular momentum of the bar about the axle?

Answers: 3

Answer

Physics, 22.06.2019 22:30

The record distance in the sport of throwing cowpats is 81.1 m. this record toss was set by steve urner of the united states in 1981. assuming the initial launch angle was 45° and neglecting air resistance, answer the following. (a) determine the initial speed of the projectile. m/s

Answers: 2

Answer

Physics, 23.06.2019 02:00

Compare the maximum rate of heat transfer to the basal metabolic rate by converting a bmr of 88 kcal/hr into watts. what is the value? from this comparison you should see why the body can accommodate a modes amount of activity in hot weather but strenuous activity would increase the metabolic rate above the body's ability to remove heat [12].

Answers: 3

Answer

You know the right answer?

Two resistors of resistances R1 and R2, with R2>R1, are connected to a voltage source with voltag...

Questions