subject
Physics, 23.03.2020 05:34 KariSupreme

For a final project in Seon’s physics class, students were instructed to build a water balloon launcher, write a hypothesis, and then carry out an experiment with the launcher. Considering that 90 degrees means launching the balloon straight up into the air and 0 degrees means launching it straight along the ground, Seon first wrote the hypothesis below.

If the angle at which the balloon is launched decreases from 90 degrees, then the distance that the balloon goes along the ground will increase, because more energy will go into pushing the balloon forward than upward.

Seon found that this was true until the angle reached about 45 degrees, and then the distance along the ground began to decrease again. Seon knows that he will need to write a new explanation, but he would like to conduct an experiment that is based on his original hypothesis, with one of the variables changed.

How could Seon rewrite his hypothesis to be a statement that will more likely be supported?

a. change the independent variable to “If the angle at which the balloon is launched increases up to 90 degrees . . .”

b. change the dependent variable to “If the angle at which the balloon is launched moves closer to 45 degrees . . .”

c. change the independent variable to “If the angle at which the balloon is launched moves closer to 45 degrees . . .”

d. change the dependent variable to “If the angle at which the balloon is launched increases to 90 degrees. . .”

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 07:20
If the ama of the inclined plane below is 2, calculate the ima and efficiency. ima = efficiency =
Answers: 1
question
Physics, 22.06.2019 14:00
This is one type of line graph in which the independent variable is time plotted on the x axis and the dependent variable, also numerical, is plotted on the y axis.
Answers: 2
question
Physics, 22.06.2019 18:00
Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)
Answers: 3
question
Physics, 22.06.2019 18:30
4. now look at the green lines you created by connecting the three boiling point data points and the three melting point data points. for each of these lines, describe any trends you see. 5. locate the elements on your periodic table that you circled in green on your graph. what term or description would you use to identify these elements with respect to the periodic table? 7. using the room temperature line (orange line) and your periodic table, make lists that identify the state of matter (gas, liquid, or solid) in which each element you plotted exists at room temperature. explain your answers.
Answers: 2
You know the right answer?
For a final project in Seon’s physics class, students were instructed to build a water balloon launc...
Questions
question
English, 22.09.2019 02:20
Questions on the website: 13722363