subject
Physics, 16.03.2020 20:51 Nathaliasmiles

Two balls with the same mass are located at the bottom of an incline. They are given the same initial linear velocity up the incline and roll without slipping. One ball is solid and the other is a thin-walled hollow ball. Which rolls higher up the incline before coming to a stop?

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 23:30
Ablock of mass m = 2.5 kg is attached to a spring with spring constant k = 790 n/m. it is initially at rest on an inclined plane that is at an angle of 28 degrees with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is k = 0.14. in the initial position, where the spring is compressed by a distance of a = 0.18 m, the mass is at its lowest position and the spring is compressed the maximum amount. take the initial gravitational energy of the block as zero. b) if the spring pushes the block up the incline, what distance, l, in meters will the block travel before coming to rest? the spring remains attached to both the block and the fixed wall throughout its motion.
Answers: 1
question
Physics, 22.06.2019 02:50
Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)
Answers: 3
question
Physics, 22.06.2019 12:50
Air is contained in a variable-load piston-cylinder device equipped with a paddle wheel. initially, air is at 400 kpa and 17°c. the paddle wheel is now turned by an external electric motor until 75 kj/kg of work has been transferred to air. during this process, heat is transferred to maintain a constant air temperature while allowing the gas volume to triple. calculate the required amount of heat transfer in kj/kg.
Answers: 2
question
Physics, 22.06.2019 18:30
An electron in an x-ray machine is accelerated through a potential difference of 1.00 × 104 v before it hits the target. what is the kinetic energy of the electron in electron volts?
Answers: 2
You know the right answer?
Two balls with the same mass are located at the bottom of an incline. They are given the same initia...
Questions
question
Mathematics, 28.04.2021 21:50
question
Mathematics, 28.04.2021 21:50
question
Mathematics, 28.04.2021 21:50
Questions on the website: 13722367