Physics, 10.03.2020 08:06 bryanawesome23

Usually wire resistance can be neglected. But we see the effect of it sometimes when a light dims as another high-current device is turned on. In the fridge, the bulb will put out a little less power when the switch to the compressor motor is turned on.
a. The voltage source (wiggly circled curve) is 120 V (treat it like a battery) and the wire resistance is 0.5 ohms. The bulb is rated as "75W", which means its power is 75W when connected to 120 V. What is the resistance of the bulb? (ohms)
b. When the switch to the motor is open (preventing that branch of the circuit from receiving current, so you can pretend it is not even there), find the power consumed by the bulb, which should be a little lower than 75W because of the wire resistance. (W)

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 05:30

Which of the following are considered noble gases? a. bromine b. neon c. argon d. chlorine

Answers: 1

Answer

Physics, 22.06.2019 08:20

At an oceanside nuclear power plant, seawater is used as part of the cooling system. this raises the temperature of the water that is discharged back into the ocean. the amount that the water temperature is raised has a uniform distribution over the interval from 10° to 25° c. what is the standard deviation of the temperature increase?

Answers: 1

Answer

Physics, 22.06.2019 14:20

4r-134a enters the condenser of a residential heat pump at 800 kpa and 50°c at a rate of 0.022 kg/s and leaves at 750 kpa subcooled by 3°c. the refrigerant enters the compressor at 200 kpa superheated by 4°c determine (a) the isentropic efficiency of the compressor, (b) the rate of heat supplied to the heated room, and (c) the cop of the heat pump. also, determine (d) the cop and rate of heat supplied to the heated room if this heat pump operated on the ideal vapor-compression cycle between the pressure limits of 200 and 800 kpa. (0.757, 4.37 kw, 5.12, 6.18, 3.91 kw)

Answers: 3

Answer

Physics, 22.06.2019 15:50

The california mussel (mytilus californianus) attaches itself to a rock or other solid surface with a bundle of filaments known as the byssus. imagine that 15.0 j of work is done to stretch the distal end of the byssus. it releases 10.8 j of thermal energy as it relaxes. what is the resilience of the distal end of the byssus?

Answers: 2

Answer

You know the right answer?

Usually wire resistance can be neglected. But we see the effect of it sometimes when a light dims as...

Questions