Physics, 06.03.2020 14:52 hannahkelly3618

Two colours of light which mix to make white light are called
a) primary colours
b) secondry colous
c) complementary colours
d) dye

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 02:50

20. threshold braking in the vehicle's braking system occurs when a. the brake pedal is pushed, heel on floorboard, with full foot pressure. b. the brakes are exerting full braking power, without traction loss. c. the driver begins pushing down the brake pedal, with moderate slowdown. d. the brakes just begin to take hold with a gradual slowdown.

Answers: 3

Answer

Physics, 22.06.2019 19:10

3. a worker pushes a 30.5 kg polished stone along a polished table with a force on bonin a straight line for 5.20 s after starting from rest. there is no friction between thestone and the table. at the end of the table. the stone is hooked to a cable with a lengthof 62.0 cm to rotate it to a rough table to store until they can be picked up. the roughtable has a coefficient of static friction 0.702 with the polished stone. remember that 8= 9.80 m/s2a) what is the speed of the stone when it is hooked to the cable? b) what is the tension in the cable while the stone is rotating? (there is still nofriction)c) how much force is needed to make the stone begin sliding from rest on therough table? ius = 0.70262.0 cm30.5 kg20.5 kg6= 0

Answers: 2

Answer

Physics, 23.06.2019 06:30

Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?

Answers: 2

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

Two colours of light which mix to make white light are called
a) primary colours
b) second...

Questions

Physics, 19.09.2021 16:30

Juan is at cross country practice and is told by his coach to run a total of 1000m. If each lap is 400m, how much is his displacement? Is it the same...

Physics, 19.09.2021 16:30

Contaminated water is subjected to a cleaning process...