subject
Physics, 10.01.2020 02:31 PastelHibiscus

describe how the piece of chalk in the image may be affected by static friction, sliding friction, fluid friction, and rolling friction. which type of friction is likely to produce the greatest amount of force on the chalk?

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 17:30
Acatapult is tested by roman legionnaires. they tabulate the results in a papyrus and 2000 years later the archaeological team reads (distances translated into modern units): range = 0.4 km; angle of launch = π/5 rad; landing height = launch height. what is the initial velocity of launch of the boulders if air resistance is negligible?
Answers: 3
question
Physics, 21.06.2019 23:00
Acoal-fired plant generates 600 mw of electric power. the plant uses 4.8 x 10^6 kg of coal each day, and the heat of combustion of coal is 3.3x 10^7 j/kg. the steam that drives the turbines is at a temperature of 300° c, and the exhaust water is at 37° c. (a) what is the overall efficiency of the plant for generating electric power? (b) how much thermal energy is exhausted each day? (c) what is the change in entropy of the universe for this heat engine? (d) using the same heat reservoirs, what is the maximum possible (carnot) efficiency for a heat engine?
Answers: 1
question
Physics, 22.06.2019 04:00
Which configuration would produce an electric current? a) rotate a coil of copper wire between two magnets. b) connect a wire between a copper and zinc strip sitting in a beaker of water. c) connect a wire to the (+) positive end of a battery and the other end to a light bulb. d) connect a wire to the negative end of a battery and the other end to a light bulb.
Answers: 2
question
Physics, 22.06.2019 05:10
Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.
Answers: 3
You know the right answer?
describe how the piece of chalk in the image may be affected by static friction, sliding friction, f...
Questions
question
Chemistry, 15.10.2019 14:50
question
Social Studies, 15.10.2019 14:50
question
Mathematics, 15.10.2019 14:50
Questions on the website: 13722367