High-power lasers are used to cut and weld materials by focusing the laser beam to a very small spot. this is like using a magnifying lens to focus the sun's light to a small spot that can burn things. as an engineer, you have designed a laser cutting device in which the material to be cut is placed 7.0cm behind the lens. you have selected a high-power laser with a wavelength of 1.06 \mum. (this distance and wavelength are both very typical values.) your calculations indicate that the laser must be focused to a 7.0\mum-diameter spot in order to have sufficient power to make the cut. what is the minimum diameter of the lens you must install? express your answer with the appropriate units.

Search coils and credit cards. one practical way to measure magnetic field strength uses a small, closely wound coil called a search coil. the coil is initially held with its plane perpendicular to a magnetic field. the coil is then either quickly rotated a quarter-turn about a diameter or quickly pulled out of the field. (a) derive the equation relating the total charge q that flows through a search coil to the magnetic-field magnitude b. the search coil has n turns, each with area a, and the flux through the coil is decreased from its initial maximum value to zero in a time ∆t. the resistance of the coil is r, and the total charge is q = i∆t, where i is the average current induced by the change in flux. (b) in a credit card reader, the magnetic strip on the back of a credit card is rapidly “swiped” past a coil within the reader. explain, using the same ideas that underlie the operation of a search coil, how the reader can decode the information stored in the pattern of magnetization on the strip. (c) is it necessary that the credit card be “swiped” through the reader at exactly the right speed? why or why not?

Agroup of students is studying convection currents. they fill two identical balloons with the same amount of helium. one balloon is placed in a freezer and the other in an area with warm air. after 10 minutes, the balloons are released from a height of 1 meter. which of the following do the students most likely observe? question 2 options: the balloons rise at the same rate. both balloons are the same size. the ballons both rise. the cold ballon is larger than the warm balloon. the cold balloon expands and rises. the warm balloon shrinks and sinks. the warm balloon expands and rises. the cold balloon shrinks and sinks.

In science and physics what is the standard unit of measure for speed?