Physics, 29.11.2019 01:31 Jmorrow4436

Arubber wheel on a steel rim spins freely on a horizontal axle that is suspended by a fixed pivot at point p. when the wheel spins at a rate of 4.00 rev / s, it precesses smoothly about point pin a horizontal plane with a period of 3.50 s. the wheel's outer radius is 15.0 cm, and it's total mass is measured to be 1.12 kg, 60% of this being the spinning wheel and 40% its axle assembly. the wheel and its axle are both symmetric about the middle of the wheel, and the pivot point p is 4.70 cm from the wheel's middle. down b (a) draw an extended free-body diagram for the wheel + its axle considered as a body. (b) what is the direction of the net torque on the wheel about the pivot point p? (c) if the wheel is spinning counterclockwise (5) as seen from point b on the wheel's axle, what is the direction of its spin angular momentum referenced to the diagram? (d) as seen from point a above the pivot, which way is the wheel precessing (c or o)? give your reasoning. (e) using this information, determine the moment of inertia i of the wheel about its axle. be sure your work is clear. [hint: various unit conversions need to be done before you can do numerical calculations.] (f) if the wheel's moment of inertia is assumed to be of the form i = cmr, where r is the wheel's radius and m is the amount of mass that is spinning, what is the constant c? how does it compare with the range of values you might expect for a wheel whose spinning mass is not concentrated all at its outer rim nor is distributed uniformly between its axle and rim? explain. (g) in order to stop the wheel's precession without causing any other precessional motion of the axis up or down, in which direction should a force be applied to point b at the axle's end? why? how should the magnitude of this force compare with the wheel's weight? explain. (h) what is the magnitude of the vertical component of force acting on the axle at point p due to the pivot? (i) why must there be a horizontal component of force acting on the axle at point p due to the pivot? what is the magnitude of this component?

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 21:20

Which of the following explains why it took so long for the public to accept the negative health effects of smoking? a)people were waiting for counter reasons, and those were presented.b)scientists had not completely finalized their results, which took 30 years.c)cigarettes were cheaply available and media channels were very inefficient.d)cigarette manufacturers were trying hard to bring an alternative into the market

Answers: 3

Answer

Physics, 21.06.2019 22:00

Bob camina 200 m sur, luego trota 400 m suroeste, luego camina 200 m en una dirección 30? norte del este. a. dibuje una gráfica de los movimientos de bob. use una regla y transportador. b. use método gráfico y analíitico para hallar el desplazamiento total que bob recorrió. (magnitud y dirección) c. compare los resultados obtenidos por el método gráfico y analítico. (por ciento de diferencia).

Answers: 2

Answer

Physics, 22.06.2019 01:00

Need asap ! what is the relationship between atmospheric pressure and the density of gas particles in an area of increasing pressure? (2 points) as air pressure in an area increases, the density of the gas particles in that area decreases. as air pressure in an area increases, the density of the gas particles in that area increases. as air pressure in an area increases, the density of the gas particles in that area remains constant. as air pressure in an area increases, the density of the gas particles in that area increases and decreases in an alternating pattern. 3. which of the following correctly describes a way in which earth's atmosphere interacts with the geosphere? (2 points) it contains gases that living organisms breathe. it contains gases that trap incoming solar radiation. it provides a medium for cycles that provide nutrients to living organisms. it provides a medium for water to move between earth's surface and the air. 4. which of the following is considered a drawback to using wind energy as a source of power? (2 points) wind energy is nonrenewable. wind energy produces large amounts of air pollution. 5. a meteorologist predicts that the weather in a region will soon change from clear skies to probable thunderstorms. prior to making this prediction, what did the meteorologist most likely observe on a barometer? (2 points) the barometer fell slightly. the barometer fell substantially. the barometer rose slightly. the barometer rose substantially. 6. which of the following do meteorologists not typically use weather balloons to record? (2 points) atmospheric pressure cloud types humidity temperature 7. during which step in the can crush lab did water vapor force air from the can? (2 points) the can was filled nearly to the top with water. the can was placed on the hot stove top burner for several minutes. the can was removed from the hot stove top burner. the can was placed upside-down in the water-filled pan.

Answers: 2

Answer

Physics, 22.06.2019 03:00

Which process is represented by the pv diagram? a. the isobaric process b. the isovolumetric process c. the isothermal process d. the adiabatic process

Answers: 1

Answer

You know the right answer?

Arubber wheel on a steel rim spins freely on a horizontal axle that is suspended by a fixed pivot at...

Questions