Physics, 21.11.2019 00:31 esme06quirino

An architect needs to pump 2.3 lbm/s of water to the top of the empire state building, which is about 1000 ft high. assume water at 45 psia is available at the base of the building. what is the power of the pump needed, in hp, if the flow is assumed frictionless? the velocity of the water is constant.

Answers: 3

Show answers

Answers

Answer from: Quest

in simple terms, the principle states that the buoyancy force on an object is equal to the weight of the fluid displaced by the object, or the density of the fluid multiplied by the submerged volume times the gravitational acceleration, g. this is also known as upthrust.

Answer from: Quest

b.transmitters send radio waves, and receivers capture radio waves.

Answer from: Quest

force is based upon mass and acceleration.the statement is not always true.

it can be explained from newton's second law of motion.

as per newton's second law of motion the rate of change of momentum is directly proportional to the applied force and takes place along the direction of force.

mathematically it can be written as -

$f\alpha \frac{dp}{dt}$

⇒ $f= k \frac{dp}{dt}$

here k is the proportionality constant whose value is 1.

$f=\frac{dp}{dt}$

$f= \frac{d[mv]}{dt}$

$f= m\frac{dv}{dt} +v\frac{dm}{dt}$

$f=ma+v\frac{dm}{dt}$ [a is the acceleration=dv/dt]

hence we see that force not only depends on mass and acceleration but also on velocity and rate of change of mass. force f will depend on mass and acceleration only when mass is constant.

hence the statement that force is based upon mass and acceleration is false.

Answer from: Quest

The purpose of a lab is to do your "expirements" the importance of the topic is so you can now what the story is about and the last one is because no one is me with my question ( what is 3 over 4 x - 9 = 27 maybe you can )

Another question on Physics

Physics, 21.06.2019 17:30

Acatapult is tested by roman legionnaires. they tabulate the results in a papyrus and 2000 years later the archaeological team reads (distances translated into modern units): range = 0.4 km; angle of launch = π/5 rad; landing height = launch height. what is the initial velocity of launch of the boulders if air resistance is negligible?

Answers: 3

Answer

Physics, 22.06.2019 07:00

Critical mass is the of material required to produce a chain reaction. a.) minimum amount b.) atomic mass c.) precise amount d.) maximum amount

Answers: 1

Answer

Physics, 22.06.2019 19:10

3. a worker pushes a 30.5 kg polished stone along a polished table with a force on bonin a straight line for 5.20 s after starting from rest. there is no friction between thestone and the table. at the end of the table. the stone is hooked to a cable with a lengthof 62.0 cm to rotate it to a rough table to store until they can be picked up. the roughtable has a coefficient of static friction 0.702 with the polished stone. remember that 8= 9.80 m/s2a) what is the speed of the stone when it is hooked to the cable? b) what is the tension in the cable while the stone is rotating? (there is still nofriction)c) how much force is needed to make the stone begin sliding from rest on therough table? ius = 0.70262.0 cm30.5 kg20.5 kg6= 0

Answers: 2

Answer

Physics, 22.06.2019 23:40

To place a communications satellite into a geosynchronous orbit at an altitude of 22,240 mi above the surface of the earth, the satellite first is released from a space shuttle , which is in a circular orbit at an altitude of 185 mi, and then is propelled by an upper-stage booster to its final altitude. as the satellite passes through a, the booster's motor is fired to insert the satellite into an elliptic transfer orbit. the booster is again fired at b to insert the satellite into a geosynchronous orbit. knowing that the second firing increases the speed of the satellite by 4810ft/s, determine (a.) the speed of the satellite as it approaches b on the elliptic transfer orbit, (b.) the increase in speed resulting from the first firing at a.

Answers: 2

Answer

You know the right answer?

An architect needs to pump 2.3 lbm/s of water to the top of the empire state building, which is abou...

Questions