At time t=0 a grinding wheel has an angular velocity of 28.0 rad/s . it has a constant angular acceleration of 35.0 rad/s2 until a circuit breaker trips at time t = 2.20 s . from then on, the wheel turns through an angle of 437 rad as it coasts to a stop at constant angular deceleration.(a) through what total angle did the wheel turn between t = 0 and the time it stopped? (b) at what time did it stop? (c) what was its acceleration as it slowed down?

Which statement best describes who the period and frequency of electromagnetic was change between gamma rays and microwaves? a) the period and frequency stay the same. b) the period increases and the frequency decreases. c) the period decreases and the frequency increases. d) the period increases and the frequency increases.

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

What is the final velocity of the initial velocity of 25 and -50?