4. the fire alarm goes off, and a 97 kg fireman slides 3.0 m down a pole to the ground floor. suppose the fireman starts from rest, slides with a constant acceleration, and reaches the ground floor in 1.2 s. (a) what was the upward force f exerted by the pole on the fireman

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Awave is produced in a rope. the wave has a speed of 33 m/s and a frequency of 22 hz.

The a992 steel rod bc has a diameter of 50 mm and is used as a strut to support the beam. determine the maximum intensity w of the uniform distributed load that can be applied to the beam without risk of causing the strut to buckle. take f.s. = 2 against bucklin