subject
Physics, 05.11.2019 03:31 samreitz1147

Two pulleys, one with radius 4 inches 4 inches and one with radius 8 inches 8 inches, are connected by a belt. if the 4 dash inch4-inch pulley is caused to rotate at 5 revolutions per minute5 revolutions per minute, determine the revolutions per minute of the 8 dash inch8-inch pulley. (hint: the linear speeds of the pulleys are the same, both equal the speed of the belt.)

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:00
There is a theory that indicates that dinosaurs became extinct when about 65 million years ago, a large asteroid hit the earth surface. dust caused by this collision blocked the sunlight reaching the earth's surface and many forms of life became extinct due to the cold. fearing this threat, how large the radius of an asteroid should you be looking for if the dangerous asteroid size is approximately the same as the one that killed the dinosaurs? available data suggests that about 18% of that asteroid's mass ended up as a dust spread evenly over earth after eventually settling out of the upper atmosphere. about 0.0180 g/cm^2 of dust, which is chemically different than the earth's rock, covered the earth's surface. typical asteroids have a density of about 1.9 g/cm^3. now that we know the size of the asteroid, how much energy was released during impact, assuming all of it was just the kinetic energy of the asteroid right before the impact?
Answers: 1
question
Physics, 22.06.2019 08:40
The system is released from rest with the cable taut, and the homogeneous cylinder does not slip on the rough incline. determine the angular acceleration of the cylinder and the minimum coeffi cient s of friction for which the cylinder will not slip.
Answers: 2
question
Physics, 22.06.2019 15:10
In the circuit, the switch s has been open for a long time and r = 125 kohm. it is then suddenly closed. (a) determine the time constant before the switch is closed. s (b) determine the time constant after the switch is closed. _ s (c) let the switch be closed at t = 0. find the current in the switch as a function of time. (use t for time. express your answer in milliamps and seconds.) i(t) =_
Answers: 3
question
Physics, 22.06.2019 19:30
Select light for the type of wave, adjust the wavelength so that the light is red, and increase the amplitude of the light to the max. then, select the start button at the source location to begin producing the waves. light is a form of electromagnetic wave, containing oscillating electric and magnetic fields. the wave amplitude detector mentioned above shows how the electric field oscillates in time at the location of the probe. the amplitude of the wave at the location of the probe is equal to the maximum electric field measured. how does the amplitude of the wave depend on the distance from the source?
Answers: 2
You know the right answer?
Two pulleys, one with radius 4 inches 4 inches and one with radius 8 inches 8 inches, are connected...
Questions
question
Mathematics, 25.09.2020 23:01
Questions on the website: 13722367