subject
Physics, 26.10.2019 23:43 andaws21

An object is placed so that the image formed is a real image of the same size as the object. what is the position of the object?
a.
b.
c.
d.
at the focal point
at a distance of twice the focal length
greater than the focal length but less than twice the focal length
at a distance less than the focal length

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 22:40
Ablock of mass m = 2.5 kg is attached to a spring with spring constant k = 710 n/m. it is initially at rest on an inclined plane that is at an angle of θ = 23° with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is μk = 0.19. in the initial position, where the spring is compressed by a distance of d = 0.16 m, the mass is at its lowest position and the spring is compressed the maximum amount. take the initial gravitational energy of the block as zero. a) what is the block's initial mechanical energy? b) if the spring pushes the block up the incline, what distance, l, in meters will the block travel before coming to rest? the spring remains attached to both the block and the fixed wall throughout its motion.
Answers: 3
question
Physics, 22.06.2019 01:00
Complete the sentence to describe the law of conservation of energy. the law of conservation of energy states that energy cannot be created or , but it can be
Answers: 1
question
Physics, 22.06.2019 01:10
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
question
Physics, 22.06.2019 02:10
How is coal extracted from mountaintop removal mines? a. dynamite is used to create underground tunnels where miners go to extract the coal. b. dynamite is used to break apart rocks and then draglines are used to remove the broken rock and reach the coal. c. coal in mountaintops is extracted by digging strips in the landscape to reach the coal. d. placer deposits in mountain river bottoms are removed by
Answers: 2
You know the right answer?
An object is placed so that the image formed is a real image of the same size as the object. what is...
Questions
question
Computers and Technology, 29.06.2021 21:30
question
Mathematics, 29.06.2021 21:30
question
English, 29.06.2021 21:30
question
Mathematics, 29.06.2021 21:30
question
English, 29.06.2021 21:30
question
English, 29.06.2021 21:30
question
Mathematics, 29.06.2021 21:30
Questions on the website: 13722367