The diagram shows the effect of solar energy on both land and sea on a hot, sunny day.

why is the air over the sea cooler even on a hot, sunny day?

question 5 options:

water has the ability to regulate its own temperature.

water keep flowing which prevents the water from heating up at all.

water needs to absorb a lot of solar energy to warm up.

water absorbs the sun's energy but does not transmit it.

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Which of the following is not a characteristic of s waves? a. travel slower than p waves. b. cannot be detected in locations more than 105° from an earthquake’s epicenter. c. travel through solids and liquids. d. only affect coastal regions.

Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?