While goofing off at the ice skating rink, a student takes off her shoes and places each of them on the ice. her friend, a hockey player, then shoots a hockey puck at each shoe. the first puck immediately comes to rest after it collides with the left shoe. the second puck rebounds after it collides with the right shoe. if each hockey puck has the same incoming speed, which shoe has greater speed after the collision?

Right shoe

Explanation:

Let the mass and velocity of incoming puck be m and v respectively.

Momentum of the colliding puck will be mv

In case of first case , the momentum of puck becomes zero so change in momentum after collision with left shoe

= mv - 0 = mv

If time duration of collision be t

rate of change of momentum

= mv / t

This is the force exerted by puck on the left shoe .

Now let us consider collision with right shoe

momentum after collision with right  shoe

- mv

change in momentum

= mv - ( - mv ) = 2mv

If time duration of collision be t

rate of change of momentum

= 2mv / t

This is the force exerted by puck on the right  shoe .

Since the force on the right shoe is more , this shoe will have greater speed

after collision.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

= initial pressure

= final pressure = 2

= initial volume

= final volume = /4

= initial temperature = 20 c = 20 + 273 = 293 k

= final temperature = ?

using the equation