A2‐in schedule‐40 steel pipe carries saturated steam at 60 psi through a laboratory that is 60 ft long. the pipe is insulated with 1.5 in of 85% magnesia that costs $0.75 per foot. how long must the steam line be in service to justify the insulation cost if the heating cost for the steam is $0.68 per 105 btu? the outside‐surface convective heat‐transfer coefficient may be taken as 5 btu/h ft2 f.

When you drop a pebble from height a it reaches the ground with speed v if there is no air resistance. from what height should you drop it so it will reach the ground with three times the speed? (a) 9m (b) 3m (c) 6m (d) 18m

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

If 2 moles of co_2 at 2l and 500k are expanded reversibly to 20l, more work can be obtained from an adiabatic process than from an isothermal process. is the above statement true or false?