subject
Physics, 18.10.2019 18:00 igotdiss2178

Running on a treadmill is slightly easier than running outside because there is no drag force to work against. suppose a 60 kg runner completes a 5.0 km race in 19minutes.

determine the drag force on the runner during the race. suppose that the cross section area of the runner is 0.72 m2 and the density of air is 1.2 kg/m3.

what is this force as a fraction of the runner's weight?

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 11:20
The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)
Answers: 3
question
Physics, 22.06.2019 19:30
The nuclear potential that binds protons and neutrons in the nucleus of an atom is often approximated by a square well. imagine a proton conned in an innite square well of length 105 nm, a typical nuclear diameter. calculate the wavelength and energy associated with the photon that is emitted when the proton undergoes a transition from the rst excited state (n 2) to the ground state (n 1). in what region of the electromagnetic spectrum does this wavelength belong?
Answers: 1
question
Physics, 23.06.2019 03:10
You have been hired to design a spring-launched roller coaster thatwill carry two passengers per car. the car goes up a 10-m highhill, then descends 15m to the track's lowest point. you'vedetermined that the spring can be compressed a maximum o 2.0m andthat a loaded car will have a maximum mass of 400kg. for safetyreasons, the spring constant should be 10% larger than the minimumneeded for the car to just make it over the top. a) what spring constant (k) should you specify ? b) what is the maximum speed of a 350 kg car if the spring iscompressed the full amount.
Answers: 2
question
Physics, 23.06.2019 07:00
What are the examples for scaler quantities
Answers: 2
You know the right answer?
Running on a treadmill is slightly easier than running outside because there is no drag force to wor...
Questions
question
Mathematics, 29.06.2021 21:10
Questions on the website: 13722367