The perceived forces between chlorine gas molecules that contribute to nonideal behavior are most strongly influenced by which of the following best explains why the two values in parts a and b are different? the high system pressure and high system temperature. the polar chlorine molecules and the low system temperature. the high system temperature and relatively large chlorine molecule size. the high system pressure and relatively large chlorine molecule size.

Plzz 10 points ! is some thermal energy always released during a transformation ? and is potential chemical energy always transformed into kinetic energy

The particle in a two-dimensional well is a useful model for the motion of electrons around the indole ring (3), the conjugated cycle found in the side chain of tryptophan. we may regard indole as a rectangle with sides of length 280 pm and 450 pm, with 10 electrons in the conjugated p system. as in case study 9.1, we assume that in the ground state of the molecule each quantized level is occupied by two electrons. (a) calculate the energy of an electron in the highest occupied level. (b) calculate the frequency of radiation that can induce a transition between the highest occupied and lowest unoccupied levels. 9.27 electrons around the porphine ring (4), the conjugated macrocycle that forms the structural basis of the heme group and the chlorophylls. we may treat the group as a circular ring of radius 440 pm, with 20 electrons in the conjugated system moving along the perimeter of the ring. as in exercise 9.26, assume that in the ground state of the molecule quantized each level is occupied by two electrons. (a) calculate the energy and angular momentum of an electron in the highest occupied level. (b) calculate the frequency of radiation that can induce a transition between the highest occupied and lowest unoccupied levels.

You have been hired to design a spring-launched roller coaster thatwill carry two passengers per car. the car goes up a 10-m highhill, then descends 15m to the track's lowest point. you'vedetermined that the spring can be compressed a maximum o 2.0m andthat a loaded car will have a maximum mass of 400kg. for safetyreasons, the spring constant should be 10% larger than the minimumneeded for the car to just make it over the top. a) what spring constant (k) should you specify ? b) what is the maximum speed of a 350 kg car if the spring iscompressed the full amount.