subject
Physics, 26.09.2019 17:10 imantahir1200345

The rigid beam bc is supported by rods (1) and (2). the cross-sectional area of rod (1) is 11 mm2. the cross-sectional area of rod (2) is 14 mm2. for a uniformly distributed load of w = 3.9 kn/m, determine the length a so that the normal stress is the same in each rod. assume l = 3.35 m.

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 01:30
The passing of heat through a material while the material itself stays in place. a. radiation b. conduction c. convection
Answers: 2
question
Physics, 22.06.2019 16:40
Which are true about beta reactions? there will be more than one answer. a. it has no change b. it doesn't change the mass of the number c. it has a mass of 0.0005 atoms d. it causes transmutation.
Answers: 3
question
Physics, 22.06.2019 21:00
Aflask with vinegar in it has a mass of 160 grams. a balloon with baking soda in it has a mass of 40 grams. the balloon is attached to the flask to seal the opening and the vinegar and baking soda mixes. the balloon inflates to a large volume. what will the total mass of the balloon and flask be after the balloon inflates? explain. a) less than 200 grams because the solid baking soda disappears. b) 200 grams, because all the atoms remain in the balloon or flask. c) more than 200 grams because the size of the balloon is so much larger. d) less than 200 grams because gases such as the one in the balloon are lighter than solids and liquids.
Answers: 1
question
Physics, 23.06.2019 06:30
Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?
Answers: 2
You know the right answer?
The rigid beam bc is supported by rods (1) and (2). the cross-sectional area of rod (1) is 11 mm2. t...
Questions
question
History, 28.06.2019 04:00
question
Biology, 28.06.2019 04:00
question
Physics, 28.06.2019 04:00
question
Arts, 28.06.2019 04:00
question
Biology, 28.06.2019 04:00
Questions on the website: 13722367