subject
Physics, 04.09.2019 20:30 ellamai10123

Someone playing a prank pulls out one of the spark plugs in your car and fills the cylinder with water, then puts the spark plug back in. when you go to start the car, the water compresses by only 0.1% before the piston rod snaps. what is the pressure on the piston face just before the rod snaps? again, you should draw a sketch of this problem – note that this is a 2-state problem and it might you to sketch initial state and final state and identify the variables involved

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 14:30
What does the term discrediting mean?
Answers: 2
question
Physics, 22.06.2019 00:00
Did the proton move into a region of higher potential or lower potential? did the proton move into a region of higher potential or lower potential? because the proton is a negative charge and it accelerates as it travels, it must be moving from a region of higher potential to a region of lower potential.because the proton is a negative charge and it accelerates as it travels, it must be moving from a region of lower potential to a region of higher potential.because the proton is a positive charge and it slows down as it travels, it must be moving from a region of higher potential to a region of lower potential.because the proton is a positive charge and it slows down as it travels, it must be moving from a region of lower potential to a region of higher potential.request answerpart bwhat was the potential difference that stopped the proton? express your answer with the appropriate units.î”v î” v = nothingnothingrequest answerpart cwhat was the initial kinetic energy of the proton, in electron volts? express your answer in electron volts.ki k i = nothing ev request answerprovide feedback
Answers: 2
question
Physics, 22.06.2019 12:30
When a vertical beam of light passes through a transparent medium, the rate at which its intensity i decreases is proportional to i(t), where t represents the thickness of the medium (in feet). in clear seawater, the intensity 3 feet below the surface is 25% of the initial intensity i0 of the incident beam. what is the intensity of the beam "10" feet below the surface? (give your answer in terms of i0. round any constants or coefficients to five decimal places.)
Answers: 2
question
Physics, 22.06.2019 23:20
What describes the particles in a liquid
Answers: 1
You know the right answer?
Someone playing a prank pulls out one of the spark plugs in your car and fills the cylinder with wat...
Questions
question
Social Studies, 15.11.2019 17:31
question
Computers and Technology, 15.11.2019 17:31
question
Mathematics, 15.11.2019 17:31
question
Mathematics, 15.11.2019 17:31
Questions on the website: 13722367