High-power lasers are used to cut and weld materials by focusing the laser beam to a very small spot. this is like using a magnifying lens to focus the sun's light to a small spot that can burn things. as an engineer, you have designed a laser cutting device in which the material to be cut is placed 7.0cm behind the lens. you have selected a high-power laser with a wavelength of 1.06 \mum. (this distance and wavelength are both very typical values.) your calculations indicate that the laser must be focused to a 7.0\mum-diameter spot in order to have sufficient power to make the cut. what is the minimum diameter of the lens you must install? express your answer with the appropriate units.
Answers: 2
Physics, 22.06.2019 01:30
The passing of heat through a material while the material itself stays in place. a. radiation b. conduction c. convection
Answers: 2
Physics, 22.06.2019 23:00
The statue of liberty is 305.5 feet high. when the angle of elevation of the sun is 50 , what is the distance to the tip of the shadow from a point at water level and directly below the highest point of the statue?
Answers: 3
Physics, 22.06.2019 23:40
A2.50 × 105 w motor is used for 26.4 s to pull a boat straight toward shore. how far does the boat move toward shore if a force of 4.20 × 104 n is applied by the motor?
Answers: 2
High-power lasers are used to cut and weld materials by focusing the laser beam to a very small spot...
English, 27.04.2021 05:50
Biology, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50
English, 27.04.2021 05:50
Engineering, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50
Mathematics, 27.04.2021 05:50