A1200-nf capacitor with circular parallel plates 2.0 cm in diameter is accumulating charge at the rate of 35 mc/s at some instant in time. (a) what will be the magnitude of the induced magnetic field 10.0 cm radially outward from the center of the plates?

Explanation:

As we know that charge on the plates of capacitor is changing at rate given as

now this rate of charging the plates will give the displacement current in the region between the plates

Now by Ampere's law we can say

now we have

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

a=d/t

a="triangle"v/t

explanation:

a = acceleration