Gthe force on a wire is a maximum of 7.50×10−2 n when placed between the pole faces of a magnet. the current flows horizontally to the right and the magnetic field is vertical. the wire is observed to "jump" toward the observer when the current is turned on. if the pole faces have a diameter of 10.0 cm , estimate the current in the wire if the field is 0.220 t

On a cold day, when the air temperature is 0°c, you empty your lungs and take a deep breath, filling your lungs with 4.2 l of air. if you hold your breath until the temperature of the air in your lungs reaches 37°c, what is the volume of the air in your lungs at that point, assuming the pressure does not change?

The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.

Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?