subject
Physics, 27.06.2019 00:40 cupcake20019peehui

Put the skater at the very top of the parabolic track on the left on top of the blue ball (make sure the little red dot under the skater is inside the ball and on the track).
1. the total energy is entirely made up of energy.
put the skater at the very bottom of the track -- on the blue ball.
2. why isn't the potential energy zero?
look for the blue-dashed line on the ground. move it up to the skater so the red dot under the skater and the line are aligned. click play.
3. why doesn't the skater go anywhere?
put the skater at the very top of the parabolic track on the left on top of the blue ball.
4. what is the height relative to the blue-dashed line (that goes through the bottom blue ball) in meters?
5. what is the total potential energy in joules -- you need to calculate it?
6. what is the total energy in joules?
with the skater still at the very top of the parabolic track on the left on top of the blue ball. click play (adjust the sim speed to your liking).
7. where is the kinetic energy the maximum? (to step through the lab click on pause and then click on the step button)
8. approximately at what point are the potential and kinetic energies the same?
9. what is the approximate speed of the skater at the point where the kinetic and potential energies are the same?
10.what is the approximate speed of the skater when at the very bottom of the track?
total energy
11.has the total energy ever changed?
12.why?

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 16:10
Alow cost, low earth orbit (leo) satellite is to be fabricated at a university, for subsequent launch by rocket. what are the constraints and objectives for selection of a material suitable for the satellite bus (i.e. the structure)? explain each in brief. (15 marks) b)suggest sources of data which could support the selection of materials for applications in space. (5 marks) c) set weights for the objectives listed in (2a) using the digital logic method. (5 marks)
Answers: 1
question
Physics, 21.06.2019 22:30
Distinguish between a transverse wave and a longitudinal wave.
Answers: 1
question
Physics, 22.06.2019 04:50
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 1
question
Physics, 22.06.2019 14:00
Give an example of a collision in real life. use the law of conservation of energy to describe the transfer of momentum. be sure and discuss the momentum before and after the collision occurs. you will need at least 3 sentences to thoroughly answer this question.
Answers: 1
You know the right answer?
Put the skater at the very top of the parabolic track on the left on top of the blue ball (make sure...
Questions
question
English, 03.12.2021 22:00
question
Mathematics, 03.12.2021 22:00
question
Health, 03.12.2021 22:00
question
Mathematics, 03.12.2021 22:00
question
Computers and Technology, 03.12.2021 22:00
Questions on the website: 13722367