Physics, 12.11.2019 14:31 brooklyn674

A5.50 kg sled is initially at rest on a frictionless horizontal road. the sled is pulled a distance of 3.20 m by a force of 25.0 n applied to the sled at an angle of 30° to the horizontal.
(a) find the work done by the applied force.
(b) find the energy dissipated by friction.
(c) find the change in the kinetic energy of the sled.
(d) find the speed of the sled after it has traveled 3 m.

Answers: 2

Show answers

Answers

Answer from: leverso

(a) 69.3 J

The work done by the applied force is given by:

$W=Fd cos \theta$

where:

F = 25.0 N is the magnitude of the applied force

d = 3.20 m is the displacement of the sled

$\theta=30^{\circ}$ is the angle between the direction of the force and the displacement of the sled

Substituting numbers into the formula, we find

$W=(25.0 N)(3.20 m)(cos 30^{\circ})=69.3 J$

(b) 0

The problem says that the surface is frictionless: this means that no friction is acting on the sled, therefore the energy dissipated by friction must be zero.

According to the work-energy theorem, the work done by the applied force is equal to the change in kinetic energy of the sled:

$\Delta K = W$

where

$\Delta K$ is the change in kinetic energy

W is the work done

Since we already calculated W in part (a):

W = 69.3 J

We therefore know that the change in kinetic energy of the sled is equal to this value:

$\Delta K=69.3 J$

(d) 4.9 m/s

The change in kinetic energy of the sled can be rewritten as:

$\Delta K=K_f - K_i = \frac{1}{2}mv^2-\frac{1}{2}mu^2$ (1)

where

Kf is the final kinetic energy

Ki is the initial kinetic energy

m = 5.50 kg is the mass of the sled

u = 0 is the initial speed of the sled

v = ? is the final speed of the sled

We can calculate the variation of kinetic energy of the sled, $\Delta K$ , after it has travelled for d=3 m. Using the work-energy theorem again, we find

$\Delta K= W = Fd cos \theta =(25.0 N)(3.0 m)(cos 30^{\circ})=65.0 J$

And substituting into (1) and re-arrangin the equation, we find

$v=\sqrt{\frac{2 \Delta K}{m}}=\sqrt{\frac{2(65.0 J)}{5.50 kg}}=4.9 m/s$

Answer from: Quest

This is what a calorimeter is used for simpler ex, to measure calories in food.

Answer from: Quest

the design of a ski jumping suit involves a trade-off between giving the skiers lift to get higher jumps and ensuring the skier does not face a lot of drag before the jump itself. an expansive suit may to lift the skier higher, but at the same time, it will also increase the air resistance. higher air resistance as the skier goes down the slope limits the speed of the jump. a big suit also increases the risk of losing balance or control, especially if there's a strong gust of wind. while technologically enhanced suits a lot, clothing is not the only factor in a ski jumper’s success. gathering speed while skiing down the slope, ensuring good speed on the ramp, and maintaining good body posture and form in the air all contribute to a ski jumper's success.

Another question on Physics

Physics, 22.06.2019 05:00

Aperson standing in a canoe exerts a force of 700 n to throw an anchor over the side. find the acceleration of the canoe if the total mass of the canoe and the person is 100 kg?

Answers: 1

Answer

Physics, 22.06.2019 12:00

Under the action of a constant force an object accelerates at 7.8 m/s2. what will the acceleration be if (a) the force is halved? (b) the object's mass is halved? (c) the force and the object's mass are both halved? (d) the force is halved and the object's mass is doubled?

Answers: 3

Answer

Physics, 22.06.2019 14:30

Which of the following changes will increase the capacitance of a parallel-plate capacitor? (there could be more than one correct choice.) a) increase the charge on the plates b) decrease the poten5al between the plates c) increase the potential between the plates d) introduce a dielectric material between the plates e) decrease the separation between the plates

Answers: 3

Answer

Physics, 22.06.2019 16:20

Amagnetic field applies forces on: a)static chargesb)moving chargesc)water flow

Answers: 1

Answer

You know the right answer?

A5.50 kg sled is initially at rest on a frictionless horizontal road. the sled is pulled a distance...

Questions