Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?

a

explanation:

no diagram was provided, but i'm guessing it's the one i've attached to my answer.

here, a mechanical force turns the rod.   this generates an electric current in the coil, which powers the bulb.

the motion of a pendulum is a classic example of mechanical energy conservation. a pendulum consists of a mass (known as a bob ) attached by a string to a pivot point. as the pendulum moves it sweeps out a circular arc, moving back and forth in a periodic fashion.

the design of a ski jumping suit involves a trade-off between giving the skiers lift to get higher jumps and ensuring the skier does not face a lot of drag before the jump itself. an expansive suit may to lift the skier higher, but at the same time, it will also increase the air resistance. higher air resistance as the skier goes down the slope limits the speed of the jump. a big suit also increases the risk of losing balance or control, especially if there's a strong gust of wind. while technologically enhanced suits a lot, clothing is not the only factor in a ski jumper’s success. gathering speed while skiing down the slope, ensuring good speed on the ramp, and maintaining good body posture and form in the air all contribute to a ski jumper's success.