Physics, 30.06.2019 03:00 greenbyron88

The mass of the water to 1.0 kg (1000 g). the cylinder has a mass of 5.0 kg and a height of 500 m. the temperature changed from 25 degrees celsius to 30.86 degrees celsius in the experiment. specific heat can be calculated using the following equation: q=mc(delta t) what is the gravitational potential energy of the cylinder? if no energy is lost, how much heat energy is added to the water? what is the mass of the water? what is the temperature change of the water? what is the specific heat of the water?

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 21:30

Aquantity of gas has a volume of 1.5 m3 and an absolute pressure of 95 kpa. when the gas is compressed to a volume of 0.5 m3, what is the new absolute pressure of the gas? (assume that there’s no change in temperature.)

Answers: 3

Answer

Physics, 21.06.2019 22:50

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.

Answers: 2

Answer

Physics, 22.06.2019 02:30

Gunpowder residue is most likely to show up where on a shooters hands

Answers: 1

Answer

Physics, 22.06.2019 06:40

Determine the change in width a, height b, thickness t when a plate is subjected to the uniform distributed load and is made of material having modulus of elasticity e=230 gpa and poisson's ratio ν=1/3. given : a=400 mm and b= 300 mm also the uniformly distributed load in downward y direction of plate is 2 mn/m and in the positive x direction is 3 mn/m and t=20 mm

Answers: 1

Answer

You know the right answer?

The mass of the water to 1.0 kg (1000 g). the cylinder has a mass of 5.0 kg and a height of 500 m. t...

Questions