Asmall plane is flying horizontally due east in calm air at 250 mi/hr when it is hit by a horizontal crosswind blowing southwest at 50 mi/hr and a 30-mi/hr updraft. find the resulting approximate speed of the plane relative to the ground to the nearest mph.

velocity of plane is given as

velocity of air

now the net speed of the plane is given as

now the net speed is

so above is the net speed of the plane

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

answer: i'm not sure which is which for i get confused on it all the time but i can tell you that the answer lies with the convex and concave devices. i hope this you. have a good day and best of luck to you!

explanation: