Physics, 11.07.2019 17:30 meganwintergirl

Ineed with questions 9. and 10.i could use an explanation too because i'm still unsure how to do this

Answers: 1

Show answers

Answers

Answer from: andy3646

This apparently is not taught or emphasized in school, and I think that's really too bad, because it can be SUPER useful and helpful:

UNITS can be multiplied and divided, just like numbers.

This why you should always KEEP the units WITH the numbers when you're working through a problem. Doing that helps tremendously to keep you on the right path as you go through it. And when you finish, it helps you decide whether your answer is correct, because the answer needs to have the correct units as well as the correct digits.

#9 says . . . kg · (m/s) · (1/s) .

How do you multiply a number by a fraction ? You multiply the numerator of the fraction by the number. You do exactly the same with units. The first multiplication in #9 is:

kg · (m/s) = (kg·m/s)

How do you multiply two fractions ? You multiply their numerators, and write THAT product over the product of their denominators. You do exactly the same with units. The second multiplication in #9 is:

(kg·m/s) · (1/s) = (kg·m·1 / s·s) and that's (kg·m / s²)

For #10, the first 2 multiplications give you

kg · s · (m/s) = (kg·m·s/s)

Now, before we go any farther ... What do you do with a fraction when the numerator and denominator both have the same factor in them ? You can 'simplify' the fraction ... divide the numerator and denominator both by the same factor, and 'cancel' it out of the fraction. You can do exactly the same with units.

Take that (kg·m·s/s) and cancel 's' out of the numerator and denominator. The simplified fraction is just kg·m .

NOW do the last multiplication in #10:

(kg·m) · (1/s²) = kg·m/s²

Answer from: Quest

Iread this book last year so take this with a grain of salt.gene jumps from the tree to compete with finny due to the fact that gene is always trying to do better than finny. he is put under the grasp of peer pressure due to finny almost forcing him to do this. ever since he first jumped finny kept pressuring him to jump since he thought gene enjoyed jumping.rather than uses this answer you should probably just reread chapters 3-4

Answer from: Quest

c) up

hope this

Another question on Physics

Physics, 22.06.2019 21:40

Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.

Answers: 1

Answer

Physics, 22.06.2019 23:00

Awelder using a tank of volume 7.50×10^-2 m^3 fills it with oxygen (with a molar mass of 32.0 g/mol ) at a gauge pressure of 3.30×10^5 pa and temperature of 37.1 ∘c. the tank has a small leak, and in time some of the oxygen leaks out. on a day when the temperature is 23.1 ∘c, the gauge pressure of the oxygen in the tank is 2.00×10^5 pa . a) find the initial mass of oxygen. b) find the mass of oxygen that has leaked out.

Answers: 3

Answer

Physics, 23.06.2019 07:00

Which best offense of relationship between speed and velocity speed is velocity what displacement velocity and speed with displacement spee is based on a specific direction velocity isis based on displacement

Answers: 1

Answer

Physics, 23.06.2019 12:00

Unlike the idealized voltmeter, a real voltmeter has a resistance that is not infinitely large. a voltmeter with resistance rv is connected across the terminals of a battery of emf e and internal resistance r. find the potential difference vmeter measured by the voltmeter. what is vmeter?

Answers: 2

Answer

You know the right answer?

Ineed with questions 9. and 10.i could use an explanation too because i'm still unsure how to do th...

Questions