subject
Physics, 19.08.2019 21:30 missmontgomery21

You will be galileo perform the experiment to determine if objects with different mass fall at the same, or different, rates in the air and in a vacuum. before you conduct your experiment, you need to form a hypothesis. a hypothesis is a prediction of what you think will happen in the experiment. the hypothesis is a statement that describes “if” a certain set of circumstances are present “then” there will be a specific result that will occur.
record your hypothesis here:
record the results from step one of the experiment (dropping the objects in the air):
first trial:
second trial:
third trial:
record the results from step two of the experiment (dropping the objects in a vacuum):
first trial:
second trial:
third trial:
did the experiment support your hypothesis? using the data from your experiment, describe why you believe your hypothesis was either proven or disproven.
what forces were acting on the objects dropped in the air? what force was acting on the objects dropped in the vacuum?
part two: comparing forceschoose two forces and compare and contrast these forces. you must provide two ways that they are alike and two ways that they are different. you may make a list, write in paragraph form, or make a chart.
choose two forces and compare and contrast these forces. these must be different forces than used in the prior question. provide two ways that they are similar and two ways that they are different. you may make a list, write it out, or make a chart.

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 03:50
The force acting on a beam was measured under the same operating conditions and a sample of 5 data points was collected. this process was repeated by 3 observers. the pooled standard deviations of these 3 data sets was 1.21. determine the true mean force using all pooled data (with a 95% probability). the result should look like this: true mean = mean +/- margin of error
Answers: 1
question
Physics, 22.06.2019 12:00
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
question
Physics, 22.06.2019 18:30
Energy can be transformed from one form to another. the diagram shows one such process. which energy transformation is represented in the diagram? nuclear to thermal and radiant nuclear to electrical and chemical chemical to nuclear and radiant chemical to electrical and nuclear
Answers: 1
question
Physics, 22.06.2019 22:30
Which of these activities increases the amount of carbon in the atmosphere?
Answers: 1
You know the right answer?
You will be galileo perform the experiment to determine if objects with different mass fall at the...
Questions
question
Mathematics, 08.10.2020 07:01
question
Mathematics, 08.10.2020 07:01
question
Mathematics, 08.10.2020 07:01
question
Mathematics, 08.10.2020 07:01
question
English, 08.10.2020 07:01
Questions on the website: 13722360