subject

Mathematics, 10.12.2020 14:00 skmc1985

The area of parallelogram is 16 cm2 , its base is 8cm, find its height?

ansver

Answers: 1

Show answers

Another question on Mathematics

question

Mathematics, 21.06.2019 15:00

An advertising firm has an old computer that can prepare a whole mailing in 6 hours. with the of newer model the job is complete in 2 hours. how long would it take the newer model to do the job alone?

Answers: 1

question

Mathematics, 21.06.2019 17:20

Consider the proof. given: segment ab is parallel to line de. prove: what is the missing statement in step 5?

Answers: 2

question

Mathematics, 21.06.2019 17:30

Which is the equation of a line perpendicular to the line with the equation 3x+4y=8

Answers: 1

question

Mathematics, 21.06.2019 19:50

If the scale factor between two circles is 2x/5y what is the ratio of their areas?

Answers: 3

You know the right answer?

The area of parallelogram is 16 cm2 , its base is 8cm, find its height?...

Questions

question

Engineering, 11.07.2019 05:10

Engine oil at 100°c and a velocity of 0.1 m/s flows over both surfaces of a 0.8-m-long flat plate maintained at 20°c. determine: (a)-the velocity and...

question

Engineering, 11.07.2019 05:10

An inventor claims to have devised a cyclical power engine that operates with a fuel whose temperature is 750 °c and radiates waste heat to a sink at...

question

Engineering, 11.07.2019 05:10

Air is compressed by a compressor from v1= 1.0 m^3/kg to v2= 0.71 m^3/kg in a reversible, isothermal process. the air temperature is maintained consta...

question

Engineering, 11.07.2019 05:10

Someone shoots an arrow upward. the arrow reaches a maximum height of 100 feet. a)-what is the initial velocity of the arrow? b)- at what time will t...

question

Engineering, 11.07.2019 05:10

What size (inner diameter) of concrete pipe (with e-0.005) is required to carry water (at 60°f) at a discharge rate of 15 ft3/s and with a head loss o...

question

Engineering, 11.07.2019 05:10

Water if flowing steadily in a 0.6-m wide rectangular open channel at a rate of 0.3 m^3/s. if the depth is 0.15 m, a)-determine i) the flow velocity,...

question

Engineering, 11.07.2019 05:10

An elevated water tower is used to supply water to a city. to make water available at a pressure of 400 kpa at a ground level location within the city...

question

Engineering, 11.07.2019 05:10

What is considered a uselapplication of modal analysis? (1) identifying the rigid body modes (2) finding modal frequencies (3) obtaining the modal am...

question

Engineering, 11.07.2019 05:10

Arefrigeration cycle rejects qn 500 btu/s to a hot reservoir at 540 r, while receiving c200 btu/s at 240°r. this refrigeration cycle a)- is internally...

question

Engineering, 11.07.2019 05:10

Acylindrical specimen of some metal alloy having an elastic modulus of 117 gpa and an original cross-sectional diameter of 3.6 mm will experience only...

question

Engineering, 11.07.2019 05:10

Arigid, insulated tank that is initially evacuated is connected through a valve to a supply line that carries steam at 3.5 mpa. now the valve is opene...

question

Engineering, 11.07.2019 05:10

Aheat pump, using ammonia as the refrigerant, has the following conditions , heat effect 75,000kj/sec , evaporator pressure 0.22mpa , condenser pressu...

question

Engineering, 11.07.2019 05:10

A2.5 cm diameter horizontal water jet with a speed of vi- 40 m/s relative to the ground is deflected by a 60° stationary cone whose base diameter is 2...

question

Engineering, 11.07.2019 05:10

For a specified inlet state, exit pressure and mass flowrate, the power input of a that of an compressor operating adiabatically and at steady state w...

question

Engineering, 11.07.2019 05:10

Asingle-cylinder four-stroke-cycle spark- ignition engine has a bsfc of 0.4 kg/kw-hr and a volumetric efficiency of 78% at a speed of 45 rps. the bore...

question

Engineering, 11.07.2019 05:10

Heat in the amount of 100 kj is transferred directly from a hot reservoir at 1200 k to a cold reservoir at 600k. calculate the entropy change of the t...

question

Engineering, 11.07.2019 05:10

A1m by 1m square gate is to be located on one vertical side of a tank that will contain 2 m depth of water up to the bottom of the gate. determine the...

question

Engineering, 11.07.2019 05:10

Acylindrical metal specimen having an original diameter of 11.80 mm and gauge length of 51.7 mm is pulled in tension until fracture occurs. the diamet...

question

Engineering, 11.07.2019 05:10

Air is compressed in an isentropic process from an initial pressure and temperature of p1 = 90 kpa and t1=22°c to a final pressure of p2=900 kpa. dete...

question

Engineering, 11.07.2019 05:10

Is a process that is internally reversible and adiabatic necessarily isentropic? explain using an equation....

More questions: Mathematics Another questions

Questions on the website: 13722360