A set of plans shows that an opening in a bulkhead is needed for a section of pipe to pass through. The plans show metric values, but the only tape measure available is marked in inches. The pipe is shown as a size DN80 (a European pipe-sizing standard), and a chart indicates the outside diameter of DN80 pipe is 88 millimeters (mm). According to the plans, all openings must be 40 mm larger than the pipe. You know that 25.4 mm is equal to one inch. What is the diameter of the needed opening in inches? Round your answer to the nearest whole inch.

the correct answer is you spend $55.78 more in a brand store that buy ing in a normal store.

step-by-step explanation:

brand = spend   $ 135.85 total

store = spend $80.07 total

there is no points to select.

step-by-step explanation:

the degrees would remain the same ( the number to the left of the decimal point.

the multiply the decimal by 60 to get the minutes and use the numbers to the left of the decimal point.

then multiply the decimal portion of that by 60 for the seconds and round off as needed.

39 .956652

the 39 remains the degrees.

the minutes = 0.956652 x 60 = 57.39912

the minutes = 57

the seconds = 0.39912 x 60 = 23.95 = 24 ( rounded to nearest tenth)

so 39.956652 = 39 degrees, 57 minutes and 24 seconds

-75.159809

the -75 remains the degrees

the minutes = 0.159809 x 60 = 9.58854

the minutes = 9

the seconds = 0.58854 x 60 = 35.31, rounded to nearest tenth = 35.3 seconds

so -75.159809 = -75 degrees, 9 minutes and 35.3 seconds.

the first coordinate is north or south, since it it positive it is north.

the second number is east or west, because it is negative it is west.

39 degrees, 57 minutes and 24 seconds n

-75 degrees, 9 minutes and 35.3 seconds w