Use a geometric model to factor 2x2 - x - 1 by following these steps:
Step 1: Model the polynomial by placing tiles in the
Product section.
Step 2: Drag one zero-pair tile to the product area. Then
use the tiles in the product area to form a
rectangle.
Step 3: Drag tiles to the sections labeled Factor 1 and
Factor 2 to represent the factors.

ONLY NEED STEP 3 plz

It is not a perfect rectangle

Step-by-step explanation: Put 2 x2 tiles side by side horizontally then place an -x tile be side it then an - tile next to the x tile

the given growth  function for the length of the fish (cm) is

f(m) = 5(1.07)m = 5.35m

where 

m = months

at the end of the study, the length is 9.19 cm. the  time for conducting the study is determined as

5.35m = 9.19

m = 1.7178 months

part a.

the study was performed over a time period  of about 1.72 months. therefore  the domain for  plotting the function is 0 < = m < = 1.72.

note:

if growth  continues at this rate for up to m months, then the domain would be 0< =m< =m.

part b.

the growth function is a linear function.

when m=0, f=0.

therefore the initial growth is zero, which represents the y-intercept.

part c.

assume that the growth function is valid for 0< =m< =9.

the average rate of change of the function is the slope of the linear function, which is 5.35 cm/month.

we need to see the graph to know but

strong positive is if it is going up from left to right in a straight diagonal line (like this /)

strong negative is the same but from right to left (like this \)

weak negative is the same as strong negative but its more straight line still right to left

and weak positive is the same as strong positive but more a straight line still left to right though.