Two stabilizing wires extend from the top of a pole to the ground, forming right triangles on
either side of the pole. One wire forms an angle of 38° with the ground and the other wire
forms an angle of 67° with the ground. The distance between where each of the wires attaches
to the ground is 30 meters. How tall is the pole?

the height of the pole is 16.1 m.

Step-by-step explanation:

The scenario is illustrated in the attached photo.

x represents the height of the pole.

y represents the distance from the foot of one stabilizing wire to the foot of the pole.

30 - y represents the distance from the foot of the other stabilizing wire to the foot of the pole.

In solving the triangles, we would apply the tangent trigonometric ratio which is expressed as

Tan θ, = opposite side/adjacent side.

Considering triangle ACD,

Tan 60 = x/y

x = ytan60 = y × 1.732

x = 1.732y- - - - - - - - -1

Considering triangle BCD,

Tan 38 = x/(30 - y)

x = (30 - y)tan38 = 0.781(30 - y)

x = 23.43 - 0.781y- - - - - - - - -2

Substituting equation 1 into equation 2, it becomes

1.732y = 23.43 - 0.781y

1.732y + 0.781y = 23.43

2.513y = 23.43

y = 23.43/2.513

y = 9.3

x = 1.732y = 1.732 × 9.3

x = 16.1 m

the sum of the lengths of any two sides of a triangle is greater than the length of the third side. if you take the three sides of a triangle and add them in pairs, the sum is greater than (not equal to) the third side. if that is not true, then it is not possible to construct a triangle with the given side lengths.

step-by-step explanation:

when rotating a figure 180 degrees, imagine that you are able to take the figure and turn it clockwise or counterclockwise around a center point. to rotate a figure 180 degrees, you will need to apply the rule (x, y) → (-x, -y). start by using a coordinate grid with coordinates for each vertex of the figure. the center point of the coordinate grid is located at (0, 0), which is what you will rotate the figure around. write down the original coordinates of the shape you are going to rotate. then, apply the rule. for example, coordinate (1, 2) becomes (-1, -2). another example would be, coordinate (-4, -2) becoming (4, 2). after you change each original coordinate to the rotated coordinate, you will draw your new figure.

step-by-step explanation: