subject
Engineering, 21.02.2023 15:20 amahar4000

Select all that are true. Group of answer choices major parts of a dc motor are stator, rotor, commutator, and brushes. If the rotor of a dc motor consists of just one conductor loop, the output torque will vary in magnitude from zero to a maximum and back to zero over every half turn of the rotor. Using multiple loops in the rotor of a dc motor not only gives higher torque but also ensures a constant magnitude of the output torque. Using electromagnets in the stator of a dc motor makes higher torque values possible. In a series motor, rotor and stator are connected in series. In a shunt motor, a bypass circuit is provided to prevent overload.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
question
Engineering, 04.07.2019 18:20
Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.
Answers: 3
question
Engineering, 05.07.2019 04:30
Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?
Answers: 2
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
You know the right answer?
Select all that are true. Group of answer choices major parts of a dc motor are stator, rotor, commu...
Questions
question
Mathematics, 16.10.2019 22:30
question
Social Studies, 16.10.2019 22:30
question
World Languages, 16.10.2019 22:30
question
Mathematics, 16.10.2019 22:30
question
English, 16.10.2019 22:30
question
Mathematics, 16.10.2019 22:30
Questions on the website: 13722360