Engineering, 17.02.2022 08:40 aaron0828

Help me!! Within the processes of a power plant, combustion product gases are available at 430 ºC. It is required to take advantage of the heat of these gases and it is proposed to size an economizer to heat pressurized water from 70ºC to 180ºC.
It is known that there is 8 kg/s of water with Cp=4260 J/kg. K. The gases have a flow of 30 kg/s and Cp=1100 J/kg. K. Calculate:
a) the heat that can be transferred from the gases to the water, in kW.
b) the outlet temperature of the combustion gases, in ºC.
b) the average logarithmic difference of temperatures of the economizer, in ºC.
c) the required heat transfer area in m2, for a counterflow configuration if the overall heat transfer coefficient is 60 W/m2 K.
d) If you plan to use a coil of tubes 4 m long and 15 cm in diameter, calculate the number of tubes needed for the economizer.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

You know the right answer?

Help me!! Within the processes of a power plant, combustion product gases are available at 430 ºC....

Questions